![]() ![]() However, there is no guarantee that interference will not occur in a particular installation.ģ If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Revisions of this document or new editions of it may be issued to incorporate such part of this document can be reproduced or transmitted in any form or by any means - electronic or mechanical - for any purpose without written permission from Mitel Networks is a trademark of Mitel Networks product names mentioned in this document may be trademarks of their respective companies and are hereby 5550 ip console User GuideRelease, Trademark of Mitel Networks Corporation Copyright 2005.Ģ Mitel Networks CorporationAll rights reservedNotices iiiNotice to Canadian CustomersThis Class A digital apparatus complies with Canadian standard to CustomersThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. Mitel and its affiliates and subsidiaries assume no responsibility for any errors or omissions in this document. The information is subject to change without notice and should not be construed in any way as a commitment by Mitel or any of its affiliates or subsidiaries. Getting Started ♦ 3 Introduction The Mitel 5550 IP Console is an attendant console and administration application for the Mitel 3300 Integrated Communications Platformġ USER GUIDENOTICEThe information contained in this document is believed to be accurate in all respects but is not warranted by Mitel Networks Corporation ( Mitel ). Revisions of this document or new editions of it may be issued to incorporate such part of this document can be reproduced or transmitted in any form or by any means - electronic or mechanical - for any purpose without written permission from Mitel Networks is a trademark of Mitel Networks product names mentioned in this document may be trademarks of their respective companies and are hereby 5550 ip console User GuideRelease, Trademark of Mitel Networks Corporation Copyright 20 USER GUIDENOTICEThe information contained in this document is believed to be accurate in all respects but is not warranted by Mitel Networks Corporation ( Mitel ). We powered off the keypad and rebooted the IP Console PC many times.Example: marketing Search 5550 IP Console - Mitel Edocs We even tried an "IP LOAD 2 and that did not seem to work. I am not very familiar with the 5550 keypad.īut, there is a passthru Ethernet cable that the PC connects thru it and why does the PC seem to talk to the 3300 and we can get into the Web Admin Gui as well? ![]() We also changed the IPPBX? variables in the SystemSettings.cfg in config dir for the IP console to the correct 3300 IP address and then back to the original again.Īppeared that the keypad was at fault - it had a "red" light indicator lit as if it was disconnected or not talking to the 3300? Of course - we could ping the 3300 from the IP console PC. We tried changing the network configuration of the 3300 by just one subnet.Īnd after a 3300 reboot - we could not see the IP console.Īlthough the console could pickup a DHCP address and showed it came from the e2t Switch(3300) and and the tech's laptop also was picking up DHCP as well. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |